Filter
Top Products
Installation
STE P 7 Install Light and Lens
PROCEDURE: Install a light bulb, (75 Watts Max-
imum) in socket as shown The light will turn on and
remain lit for 4-!/2 minutes when power isconnected
After 4-1/2 minutes it will turn off
If light bulb burns out prematurely due to vibra-
tion, replace with a "rough service" bulb.
INSTALLING LENS:
Slide lens into the lens guides as shown Snap bottom
tabs into lens slots
Len
Guide
Lighl Lens _ab _ 75LightWattBulbMaX
STE P 8 ConnectElectricPower
TO AVOID SERIOUS PERSONAL INJURY FROM ENTANGLEMENT, REMOVE ALL ROPES
CONNECTED TO THE GARAGE DOOR BEFORE OPERATING OPENER.
TO AVOID DAMAGE TO GARAGE DOOR AND OPENER, MAKE DOOR LOCKS INOPERATIVE
BEFORE CONNECTING ELECTRIC POWER. USE A WOOD SCREW OR NAIL TO HOLD THE
LOCKS IN "OPEN" (UNLOCKED) POSITION°
INSTALLATION AND WIRING MUST BE IN COMPLIANCE WITH LOCAL ELECTRICAL AND
BUILDING CODES.
OPERATION AT OTHER THAN 120V 60Hz WILL CAUSE OPENER MALFUNCTION AND DAMAGE.
Opener MUST be permanently wired or plugged into
a grounded 3-prong receptacle wired according to
local electrical codes DO NOT use a 2-wire adapter
DO NOT use an extension cord
PERMANENT WIRING
CONNECTION
RIGHT WRONG
IF LOCAL CODES REQUIRE PERMANENT WIRING:
DISCONNECT POWER AT FUSE BOX
BEFOREPROCEEDING.
PROCEDURE: Refer to illustration Make connec-
tion through the 7/8 inch diameter hole in top of
opener chassis
1 Remove opener chassis cover by removing the
cover screws
2 Remove attached 3-prong cord
3 Connect the black (line) wire to the black wire on
terminal block; white (neutral) wire to the white
terminal wire; the green (ground) wire to green
ground screw
Ground Tab
iround Screw
Ground Wire
Wife
CAUTION: BE SURE THAT UNIT IS GROUNDED
ACCORDING TO LOCAL CODE,
IMPORTANT NOTE: TO AVOID INSTALLATION
DIFFICULTIES, DO NOT RUN OPENER NOW.
14