Craftsman 139.53335SRT3 Garage Door Opener User Manual


 
Installation Step 5
Hang the Opener
Two representative installations are shown.
Yours may be different. Hanging brackets should
be angled, Figure 1, to provide rigidsupport. On
finished ceilings, Figure 2, attach a sturdy metal
bracket to structural supports before installing the
opener. The bracket and fastening hardware are not
_rovided. See accessory page 38.
Measure the distance from each side of the opener
to the structural support.
Cut both pieces of the hanging bracket to required
lengths.
Drill 3/16" pilot holes in the structural supports.
Attach one end of each bracket to a support with
5/16"-18xl -7/8" lag screws.
Fasten the opener to the hanging brackets with
5/16"-18x7/8" screws, lock washers and nuts.
Check to make sure the T-rail is centered over the
door (or in line with the header bracket if the
bracket is not centered above the door).
Remove the 2x4. Operate the door manually. If the
door hits the rail, raise the header bracket.
Grease the top and underside of the_
rail surface where the trolley __
slides. A tube of grease is /__
supplied.
Hardware Shown Actual Size
I!!l!l!;LI!
5/16'18xl-7/8"
Hex Screw
5/16'- 18x7/8" Nut 5/16"-18 Lock Washer 5/16"
Figure 1
Supports
Measure
Screws
5/15/-18xl-7/8'
5/16'-18x7/8" Screw
_16" Lock Washer
5/16"-18 Nut
Figure 2
Hidden / " _ t
Support I " " /
/. / "_ _ _._f _ _ -- FINISHED CEILING --
- _ Lag Screws
- 5/16 -18xl-7/5/_ _ "
Bracket o o o o _ _- .
. ."-_ ___5/16" Lock Washer.u,
5/16 18_
17