Filter
Top Products
Precaution
How to use Troubleshooting
Direction for use
Fill with water before plugging the power cord.
(No water may cause nebulizer malfunction.)
Coins, nails and screws in the reservoir result in the malfunction of the nebulizer
part. Please check before starting. In addition, disconnect the water tank, drain
the water in the reservoir thoroughly and check if the air-cleaning filter is mounted
on the bottom of the appliance.
After initially filling with the water, the humidification starts after approx. 1minutes.
Wash the water tank before initial use to spray more comfortable mist.
Turn the soft water tank cap anti-
clockwise to open the cap.
Detach the mist outlet and lift
out the water tank.
Fill water in the water tank.
Filling the water tank
Turn the soft cap clockwise until the cap is
closed thoroughly.
Fit the mist outlet in the water tank so it
faces the front of the appliance for
spraying.
Lift out the water tank by using the
handle on the lower water tank.
If the water tank is carryed with
the mist outlet attached, the
appliance may be damaged by
twisting of the mist outlet.
After topping up with water, dry the water tank
with a clean cloth.
Use clean tap water.
Do not use cold water below 42.8(6and warm
water above 9535
Doing so may cause nebulizer malfunction.
The use of underground water or water with
a lot of rust or dregs may cause weak mist
output or appliance failure.
Close the cap after aligning the ‘Close’ mark
to the cap mark and the bottom mark
of the tank.