Filter
Top Products
1.
While firmly supporting fixture head, use 3/8-16 x1" end screw to secure fixture head to yoke arms.
2.
Slide one aiming screw spacer between fixture head and yoke arm on each side and secure fixture heads angle using 1/4-
20 x1" aiming screws. Repeat for second fixture.
3.
Remove electrical cover plate from pendant tube.
4.
Insert fixture head wire into wire connection at base of pendant tube and run up to electrical cover plate.
5.
Insert wire from second fixture head into opposite wire connector and run wire to electrical cover plate.
6.
Attach appropriate wires ensuring all connections are properly matched and replace electrical cover plate.
Mounting and Wiring Fixture Heads to Pendant
End cap
(x4)
3/8-16 x1"
End screw
(x4)
1/4-20 x1"
Aiming screw
(x4)
Electrical cover
plate
Wire connector
2nd fixture head
removed for clarity.
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
4.
Sheet 2 of 3
Roundel, XL
IN/OUTDOOR
P2R
(Pendant, 2-way, Remote)
Visor and Non-Visor
3.
ADY080868 REV A(ECN080377)
1.
To aim fixture, unscrew end caps from fixture. Loosen both 1/4-20 x1" aiming screws on both sides of fixture. When
yoke indicator and fixture head indicator are lines up the slope of the fixture head is 40-degrees. Each subsequent notch
is an additional 10-degrees. When fixture is rotated to desired angle, secure with aiming screws.
2.
Secure door using proper torque specifications and sequence as described in supplementary sheet.
3.
Thoroughly check seal on all gaskets and wire connectors to ensure seals are smooth and compressed.
Sealing and Aiming the Fixtures
End cap
(x4)
1/4-20 x1"
Aiming screw
(x4)
Captive door
screws
(x10)
Fixture door
Electrical cover
plate gasket
Wire connectors
(x4)
Side View
40