Filter
Top Products
7
Two-year limited warranty
Cooper Lighting, LLC (“the Company”) warrants this product (“the product”)
against defects in material or workmanship for a period of two years from date
of original purchase, and agrees to repair or, at the Company’s option, replace a
defective product without charge for either replacement parts or labor during
such time. This does not include labor to remove or install fixtures.
This warranty is extended only to the original purchaser of the product.
A purchaser’s receipt or other proof of date of original purchase acceptable to
the Company is required before warranty performance shall be rendered.
This warranty only covers product failure due to defects in materials or
workmanship which occurs in normal use. It does not cover the bulb or failure
of the product caused by accident, misuse, abuse, lack of reasonable care,
alteration, or faulty installation, subjecting the product to any but the specified
electrical service or any other failure not resulting from defects in materials or
workmanship. Damage to the product caused by separately purchased,
non-Company brand replacement bulbs and corrosion or discoloration of brass
components are not covered by this warranty.
There are no express warranties except as described above.
THE COMPANY SHALL NOT BE LIABLE FOR INCIDENTAL, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY. ALL
IMPLIED WARRANTIES, IF ANY, INCLUDING IMPLIED WARRANTIES OF
Call for customer service and/or missing or damaged parts (800-334-6871)
ENGLISH
Is there power to the fixture?
• Has the circuit breaker tripped?
• Is the wall switch ON?
Is the bulb screwed in completely?
• Is the bulb good? (Be careful not to over tighten.)
Is the sensor functioning properly?
• Is the sensor locked in place?
• Is light being reflected into the sensor, causing the fixture to
turn off?
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CHECKING.
• Is the unit properly grounded?
Light does not come on
or
Light comes on for only
a few seconds
Is the light sensor receiving enough light to trigger the switch?
• Perform this simple test. Shine a flashlight into the light
sensor. The fixture should switch off after two minutes (there
is an approximate 2 minute delay). This means the sensor is
not receiving enough light. Install the light shield/reflector to
shine more light onto the photo sensor.
Light does not shut off
during daytime
Light cycles on and off
Is the light sensor receiving too much reflected light?
• Perform this simple test. Cover the light sensor with your
finger or a piece of black electrical tape. The fixture should
turn on after a slight delay. This means that extraneous or
reflected light from the fixture is causing the sensor to turn the
unit off. Install the light shield/reflector to block extra light to
the photo sensor.
What to do if . . .
MD42FLW_FLB 825-0132.qxd:MD Series 325-1432.qxd 5/28/08 8:27 PM Page 7