Filter
Top Products
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
18” High VELOCITY FLOOR FAN
OPERATING INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
CAUTION: Read and follow all instructions before Operating Fan. Do not use fan
if any part is damaged or missing.
WARNING: To reduce the risk of re or electrical shock, do not expose to water
or rain.
To reduce the risk of re or electrical shock, do not use this fan with any solid state
speed control device.
RULES FOR SAFE OPERATION:
1. Never insert ngers or any other objects through the grille guard when fan is
operation.
2. Disconnect the fan when moving from one location to another.
3. Disconnect the fan when removing guards for cleaning.
4. Be sure fan is on a stable, at surface when in operation.
5. DO NOT use fan in windows. Rain and moisture may create electrical hazard.
6. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualied persons in order to avoid a hazard.
7. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
8. Children should be supervised to ensure that they do not play with the
appliance.
CLEANING
WARNING: Unplug from electrical supply source before cleaning.
- Use soft damp cloth to clean. Then wipe with dry cloth.
- Do not use a cleaning solution that is harmful to paints or plastics.
- Do not bend the blades.
- The motor bearings are permanently sealed and do not require additional
lubrication.
ASSEMBLY THE FAN
BEFORE ASSEMBLING UNIT:
Read these instructions carefully and familiarize your self with the procedure before
assembling the unit.
Check that you have all the component parts following the content list and familiarize
yourself with each part before proceeding.
Ensure you have enough space to lay out all the parts before assembly.
Take all the parts out of the plastic bag and separate them into their groups.
To avoid scratching it is recommended that you assemble the fan light on a soft
level surface.
STAND ASSEMBLY
Connect stand B to stand A by tightening xing screw.
Connect the other end of stand B to stand C by tightening xing screw.
Align the hole of stand A (left hand side) to the shock resistant block and tighten
the at washer and nut by using the knob nut. Do the same procedure on the right
hand side.
PARTS NAME AND LOCATION
KNOWING YOUR MACHINE
1. Floor Guard
2. Blade
3. Speed Switch
4. Foot
5. Stand
2
1
3
4
5