Continental Electric CE11125 Air Conditioner User Manual


 
Keep the remote controller where its
signals can reach the receiver of the
indoor unit. (a distance of 8m is allowed).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15
minutes may occur.
Location of the remote controller.
.
.
8m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
.
.
4
The remote controller uses two
dry batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment off according to the
arrow direction, then replace the
old batteries with new ones.
(2) Insert the new batteries making
sure that the(+) and (-) of battery
are installed correctly.
(3) Reattach the cover by sliding it
back into position.
After replacing batteries, set the
remote controller clock.
Replacing batteries
.
7
.
.
DRYING OPERATION
Ensure unit is plugged and power is available.
The OPERATION lamp on the display panel of
the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select COOL, HEAT (Not applicable to
cooling only models), or FAN ONLY
ON/OFF button
Push this button again to stop the air conditioner.
The FAN ONLY mode does not control temperature.
Therefore, perform only steps 1,3, and 4 to select
this mode.
Ensure unit is plugged and power is available.
The OPERATION indicator on the display panel
of the indoor unit starts flashing.
1. Mode select button (MODE)
Press to select DRY.
2.
Push the "TEMP/TIME" button to set the desired
temperature
3. ON/OFF button
TEMP/TIME button
from 21 C/70 F to 28 C/82 F.
When the remote controller is off, push this
button to start the air conditioner.
OoO
ON/OFF button
Push this button again to stop the air conditioner.
2. TEMP/TIME button
Set the desired temperature, the most comfortable
temperature is between
21 C/70 F to 28 C/82 F.
O
3. Fan speed button (FAN SPEED)
Press to select "AUTO" "LOW", "MED" and "HIGH"
4. ON/OFF button
When the remote controller is off, push this
button to start the air conditioner.
Start
Stop
Start
Stop
Note: The fan speed cannot be adjusted when
the unit is in AUTO and DRY mode.
Cooling/Heating/Fan onlyoperation
Handling theremote controller
1
2
4
3
CLOCK
SET TEMP.SET TEMP.
FANSPEEDFANSPEED
MODE
ENERGYSAVER
CLEANAIR
FOLLOWME
SLEEP
LED
CLOCK
CANCEL
TIMER
FAN
RESET
LOCK
1
2
3
CLOCK
SET TEMP.SET
TEMP.
FANSPEEDFAN
SPEED
MODE
ENERGYSAVER
CLEANAIR
FOLLOWME
SLEEP
LED
CLOCK
CANCEL
TIMER
FAN
RESET
LOCK
F
F
COOLING/HEATING/FAN ONLY OPERATION
HANDLING THE REMOTE CONTROLLER