Conair 10 Heat Pump User Manual


 
Positive Displacement Pump IMB036/0898
1
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by
following the procedures outlined below and elsewhere in
the User Guide.
ATTENTION:
READ THIS SO NO
ONE GETS HURT
WARNING: Voltage hazard
This equipment is powered by three-phase
alternating current, as specified on the machine
serial tag and data plate.
Always disconnect and lock out the incoming
main power source before performing
non-standard operating procedures, such as
routine maintenance. Only qualified personnel
should perform troubleshooting procedures that
require access to the electrical enclosure while
power is on.
WARNING: Improper installation,
operation or servicing may result in
equipment damage or personal injury.
This equipment should be installed, adjusted,
and serviced by qualified technical personnel
who are familiar with the construction, opera-
tion and potential hazards of this type of
machine.
All wiring, disconnects and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the the machine serial tag and
data plate.