Filter
Top Products
8
104463
VENT-FREE NATURAL GAS STOVE HEATER
INSTALLATION
Continued
Figure 6 - Laying Down Stove On Back (Stove Style May Vary Depending on Model)
Front of
Stove Unit
Pallet Wood
Bolted to
Stove Body
Bottom
Top of Stove Unit
Front of
Stove Unit
Top of
Stove
Unit
Drop Cloth/
Blanket
5. Remove all contents from inside stove
cavity. Contents include:
(1) - Stove bottom
(4) - Legs (Amity models include leg
leveler bolts)
(1) - Bottom door
(1) - Top grate
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to
attach bottom components to stove
body (see Figure 6). Rest stove on drop
cloth or blanket to avoid scratching
stove edges.
7. Remove remaining pallet wood at-
tached to bottom of stove body (see
Figure 7). Use an adjustable wrench to
remove bolts.
8. Fasten each leg to stove with four (4)
bolts. Use a flat screw driver to tighten
bolt to leg. Thread bolt in tapped holes
on stove body (see Figure 8 and Figure
9, page 9).
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and Door Attachment
(Appearance May Vary Depending on Model)
Leg
Hole
Leg
Hole
Leg
Hole
Leg
Hole
Door Hinge Step
Bolt Hole
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Stove
Bottom
Holes
Front
Bottom Of
Stove Unit
STOVE CAVITY ASSEMBLY
1. Lift off corrugated box enclosing stove
body crating.
2. Remove all screws fastening the wood
frame enclosure. Spread wood frame
open and lift away from plastic-bagged
stove body. The bottom pieces of pal-
let wood will remain bolted to the stove
body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see
Figure 5). Use an adjustable wrench or
a 10 mm socket. Remove six (6) bolts
and washers. Keep bolts and washers
to reattach back panel later.
Figure 5 - Removing Back Panel
Bolt
Product
Identification Label
Back Stove Panel
Pallet
Wood
Bolt
Pallet
Wood
Bottom Of
Stove Unit
Front