Filter
Top Products
To Attach Fuel Bottle
5
■ Make sure FUEL VALVE is fully “OFF” (Fig 12).
■ Connect hose to threaded fitting on fuel bottle, making sure the bottle is lying
on its side with the fuel valve up. Hand tighten the connection (Fig. 13).
FIG. 16
FIG. 12
FIG. 13
FIG. 15
Initial Fueling of Dry Pump
6
■ Make sure FUEL VALVE is fully “OFF” (Fig 14).
■ Turn flame adjuster to “High/Light” (Fig. 15).
■ Place thumb over hole in PUMP KNOB and pump five full
strokes (Fig 16).
■ Open fuel valve on bottle 1/2 turn for five seconds, then close fuel valve.
NOTE: Air in the dry pump is now replaced with liquid fuel. Proceed to Step 7.
Note: For proper lighting, perform Step 6
ONLY for the first time use “out of the box”
or when pump is dry (for example, after
extended storage). This step is not required
during subsequent lighting.
FUEL VALVE
FIG. 14
English-7