Filter
Top Products
5
Ƶ NOTE: Heater is
designed to be lit with
the valve fully open until
it reaches full output.
Observe heat build up for
a few minutes to ensure
heater is lit. If heater fails
to develop substantial
heat, turn heater “OFF”
and repeat lighting
procedure.
Electronic Ignition
Ƶ Turn valve to HI
position and repeatedly
push red ignition button
until heater ignites.
Ƶ Heater will ignite with
a brief visible flame after
10-12 seconds.
Ƶ Heater is adjustable to
“HI” and “LOW”.
To Light cont
To Turn Off
Ƶ Turn FUEL VALVE to
OFF.
Ƶ Allow HEATER to cool
for 10-15 minutes.
To Store
DANGER
• EXPLOSION - FIRE HAZARD
t
Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
Ƶ.BLFTVSF)FBUFSJT
cool.
Ƶ5BLFVOJUPVUEPPSTBXBZ
from any ignition sources.
Remove Cylinder from
Heater.
Ƶ Replace plastic cap on
cylinder.
Ƶ Store propane cylinder consistent with the
instructions and warnings on the cylinder.
To Store cont
Things You Should Know
1. This is a catalytic heater. Burning occurs
within the pad at a lower temperature than
a normal flame due to evenly distributed
platinum. But, heat guard and burner rim still
get hot enough to burn you. Be careful.
5IFDBUBMZUJDQSPDFTTUBLFTBQQSPYJNBUFMZ
minutes to reach full heat output.
%POPUVTFIFBUFSGPSDPPLJOHPSXBSNJOH
items, this can destroy combustion and
catalyst. This heater has a low burn
temperature (no flame) but it can still burn
clothing, sleeping bags, etc., that might fall on
the burner surface.
4. To avoid damage to the catalyst, do not
allow head pad to come in contact with or
around silicone based hand creams, paints, etc.
5. Do not touch the gray ceramic fiber head
QBEPSQPLFBIPMFJOUPJU
6. Do not attempt cleaning the head assembly.
Match Light
Ƶ Hold match as shown.
Ƶ Turn valve to HI
position.
Ƶ Heater will ignite with
a brief visible flame after
10-12 seconds.
Ƶ Heater is adjustable to
“HI” and “LOW”.