Electronic Ignition
■ Turn valve to HI
position and push the red
IGNITOR BUTTON until
heater ignites (10-12
seconds).
■ Heater will ignite with a
brief visible flame.
■ Heater is adjustable to “HI” and “LOW”.
■ NOTE: Heater is
designed to be lit with
the valve fully open until
it reaches full output.
Observe heat build up
for a few minutes to
ensure heater is lit. If
heater fails to develop
substantial heat, turn
heater “OFF” and repeat
lighting procedure.
To Light cont
To Turn Off
■ Turn FUEL VALVE to
OFF.
■ Allow HEATER to
cool for 10-15 minutes.
DANGER
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
To Store
Support Leg Assembly
Support Leg
Match Light
■ Hold match as shown.
■ Turn valve to HI
position.
■ Heater will ignite with a
brief visible flame after
10-12 seconds.
■ Heater is adjustable to
“HI” and “LOW”.