Coleman 2300-700 Water Heater User Manual


 
To Set Up cont.
• Close Front Propane Access Door
• Rotate
Faucet out-
ward from
the stored
position and
place a
water collec-
tion basin
under faucet.
Use and Operation
• Clean before first use. It is strongly recommended that
you clean the heater prior to using for the first time.
Follow these simple steps before you leave home, and
then clean at least once a year or when the hose
becomes discolored with a white calcium build up.
Cleaning instructions:
1. In a clean container mix two-gallons of water with
12 oz. of calcium, lime, and rust remover (available at
the cleaner section of hardware, general merchandise
and food stores).
2. Place the pump in the container with the water/solu-
tion. The label “This Side Up” on pump should be
facing up. (Fig. 3)
3. Position the container with the water/solution so that it
is placed under the faucet.
4. Push and turn the control knob and position the knob
at the “warm” setting. (Fig. 4)
5. Circulate the water/solution through the water heater
for 2 minutes, then turn off heater by turning the knob
clockwise to the “off” position. (Fig. 5)
6. Dispose of the cleaning solution in a sink or other
drain, do not dump on the ground.
7. Fill container with 2 1/2 gallons of clean water.
8. Place the pump in the container with the water.
9. Position the water heater so the container with the
water is placed under the faucet.
10. Turn the heater on by pushing and turning the control
knob and position to the “cool” setting. (Fig. 6)
11. Circulate the clean water through the water heater for
2 minutes, then turn the knob clockwise to turn the
heater off. (Fig. 7)
12. Repeat steps 6-11 with another batch of clean water.
Hot Water on Demand
TM
is now clean and ready for use.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
6