CFM Corporation EF22 Indoor Fireplace User Manual


 
14
10009816
• Flame Speed Control
Your fireplace features a flame speed that can be controlled either by remote con-
trol or at the touchpad control panel. By depressing button 1 once, the flame effect
will be activated and turn on. By repeatedly depressing buttons 2 or 3, you can
decrease or increase the flame effect speed to achieve the desired flame effect.
Refer to the visual indicator A to monitor the relative speed of the flame effect
between the slowest (lowest light bar) and fastest (highest light bar). For your added
convenience, the flame effect speed setting is stored in memory when the flame
effect is turned off.
• Heater Control
Your fireplace features a heater with a built-in thermostat and a variable tempera-
ture setting that can be controlled either by remote control or at the touchpad con
-
trol panel. By depressing button 4 once, the heater will be activated and the LED
visual indicator B lights up to indicate the temperature setting of the heater between
the lowest (lowest light bar) and highest (highest light bar). To determine the room
temperature, depress button 5 or 6 to decrease or increase until the heater goes
off or comes on. The heater is designed to safely deliver the maximum amount of
heat when it is turned on. To increase the room temperature, depress button 6 to
increase room temperature setting. When the set temperature is reached, the heater
will automatically cycle on and off to maintain the temperature setting for the room.
It is suggested that you increase the temperature setting gradually to a room tem
-
perature that you are comfortable with. For your added convenience, the tempera
-
ture setting is stored in memory when the heater is turned off.
• Overhead Light
Your fireplace features overhead lights that add warmth and glow to the refractories
and logs. It is turned on or off either by remote control or at the touchpad control
panel. Depressing button 7 switches the overhead lights on or off while the flame is
on. If the flame is switched off, the overhead lights will go off but will come back on
when the flame is switched back on. This feature is not available on the EF
22.