Filter
Top Products
Page -8-
Clarke
®
Nap Sac Operator's Manual
GROUNDING INSTRUCTIONS 230 VOLT MACHINES
CAUTION: This machine will operate only on
AC frequency and electrical voltage shown on the
nameplate. Make sure you have the correct
frequency and voltage before connecting the power
cord to an outlet.
This machine must be connected to the electrical ground to
protect the operator from electric shock. The machine has a
power cord with two main conductors and one earthing
conductor. Connect the plug to the type of receptacle shown
in figure 1. The green and yellow conductor in the cord is the
ground wire. Never connect this wire to any terminal other
than the ground terminal.
WARNING: Always use this machine with an
AC three-conductor electrical system connected to
the electrical ground. Replace any worn, cut or
damaged cords. Replace any damaged plugs,
receptacles, or connector bodies. Do not move the
machine over an electrical cord. Always lift the
cord over the machine.
EXTENSION CORDS
Use only an approved extension cord with two main conduc-
tors and one earthing conductor. The machine has a power
cord with wire size 1.5mm
2
.
WARNING: If you use an extension cord, use
an extension cord with minimum wire size 1.5mm
2
.
Do not use an extension cord longer than 15
meters. Do not join two extension cords.
WARNING: Do not cut, remove or break the
ground terminal. Do not try to fit a three-terminal
plug into a receptacle or connector body that does
not fit the plug. If the receptacle or connector body
does not fit the plug, see your Authorized Clarke
Technology Dealer to get an authorized person to
make the connection.
DANGER: Failure to read the Operation and Parts Manual prior to operating or attempting any
service or maintenance procedure to your Clarke machine could result in injury to
you or to other personnel; damage to the machine or to other property could occur
as well. You must have training in the operation of this machine before using it. If
you or your operator(s) cannot read English, have this manual explained fully
before attempting to operate this machine.
DANGER: Operating a machine that is not completely or fully assembled could result in injury
or property damage. Do not operate this machine until it is completely assembled.
Inspect the machine carefully before operation. Use only as described in this
manual. Use only Clarke's recommended attachments.
WARNING: Operating a machine without observing all labels, decals, etc., could result in injury
or damage. Read all machine labels before attempting to operate the machine.
Make sure all of the labels are attached or fastened to the machine. Get replace-
ment labels and decals from your Clarke distributor.
CAUTION: Wrap cord around machine when not in use. Use caution not to run over cord
while machine is in use.
Figure 1
This does not apply to CE machines.