Filter
Top Products
Page 6 Clarke
®
Operator's Manual LV-30
How To Start Your Vacuum
To start your vacuum follow this procedure:
1. Make sure the spark plug is connected to the plug.
2. Move the throttle lever to the half throttle position.
See figure 3.
3. If the engine has not run for a period of time, move
the choke lever to the second detent toward the
"Arrow" mark. See figure 4.
4. Pull the starting cord handle.
5. When the engine starts, move the choke lever to the
"OFF" position.
NOTE: If the engine does not start, move the
choke to the "OFF" position. Pull the
starting cord again.
HOW TO STOP THE MACHINE
To stop the engine, follow this procedure:
1. Move the throttle to the "idle" position.
WARNING: Make sure your hand does not touch the
spark plug before the grounding strip
touches the spark plug cap. Severe
shock could occur.
2. Push the strip against the spark plug cap.
3. Hold the strip against the spark plug cap until the
engine stops.
Figure 3
Figure 4
How to Prepare The Machine for Operation