Clarke 300HV Vacuum Cleaner User Manual


 
Page 20 Clarke
®
BEXT
®
-100, 100H 150H, 300HV Operator's Manual
INSTRUCTIONS FOR CONNECTION TO THE
POWER SUPPLY AND ELECTRICAL GROUND - 120 V
CAUTION: This machine will operate only on an
AC frequency and on the specified
electrical voltage shown on the name-
plate. Make sure you have the cor-
rect frequency and voltage before
connecting the power cord to an out-
let.
This machine must be connected to an electrically grounded
circuit in order to protect the operator from electric shock.
This machine has an approved power cord with three
conductors as well as a plug with three terminals. Connect
the plug to a three holed receptacle. For maximum
protection against electric shock, use a circuit that is
protected by a ground fault circuit interrupter.
This machine uses a 120 volt AC 50/60 cycle electrical
circuit. Make sure you have the correct frequency and
voltage before connecting the power cord to an outlet. The
machine has a plug as shown in Figure 7. If a receptacle
connected to the electrical ground as shown in Figure 7 is
not available, contact an electrical contractor. Do not use
an adapter.
WARNING: To prevent possible electric shock,
protect the machine from rain. Keep
the machine in a dry building.
WARNING: To prevent possible electric shock,
always use a 3-wire electrical system
connected to the electrical ground.
For maximum protection against elec-
trical shock, use a circuit that is pro-
tected by a ground fault circuit inter-
rupter. Consult your electrical con-
tractor.
WARNING: Do not cut, remove, or break the
ground pin. If the outlet does not fit
the plug, consult your electrical con-
tractor.
WARNING: If the cords or plugs are worn or
damaged in any way, have them
replaced by an authorized service
person.
Extension Cords
Use only an approved extension cord with three conductors,
a plug with three terminals and a three-holed connector
body. This machine has a power cord with a wire size of 12
AWG. (AWG stands for American Wire Gauge).
CAUTION: If you use an extension cord, use one
that has a minimum wire size of 12
AWG. Be sure your extension cord is
no longer than 50 ft. Do not join two
extension cords.
Figure 7
Plate
Screw
Outlet must be
connected to
the electrical
ground
Ground Pin
Figura 7
Tornillo
de la
placa
Terminal de
tierra
El tomacorriente
debe estar
conectado al
borne de puesta
a tierra
Figure 7
Borne
mâle de
la prise
Fiche de terre
Le réceptacle
doit être
connecté à la
masse