Filter
Top Products
Configuring Transparent Bridging
Transparent and SRT Bridging Configuration Examples
BC-82
Cisco IOS Bridging and IBM Networking Configuration Guide
interface serial 2
bridge-group 5
bridge-group 5 circuit-group 4
!
bridge 5 domain 3
bridge 5 protocol ieee
Fast Ethernet Subscriber Port, Frame Relay Trunk Example
The following example uses the Fast Ethernet subinterface as the subscriber port and Frame Relay as the
trunk:
bridge 1 protocol ieee
# Form a subscriber bridge group using policy 1
#
bridge 1 subscriber-policy 1
bridge 1 protocol ieee
interface fast0.1
encapsulation isl 1
#
# Put fast0.1 into subscriber group 1
#
bridge-group 1
interface fast0.2
encapsulation isl 2
#
# put fast0.2 into subscriber group 1
#
bridge-group 1
interface serial0
encapsulation frame-relay
int s0.1 point-to-point
#
# Use PVC 155 as the signal channel for setting up connections with the access-server
#
frame-relay interface-dlci 155
#
# Set the trunk to go upstream
#
bridge-group 1 trunk
ATM Subscriber Ports, ATM Trunk Example
The following example uses ATM subinterfaces as the subscriber ports and the ATM as the trunk:
bridge 1 protocol ieee
#
# Use subscriber policy 3
#
bridge 1 subscriber-policy 3
#
# Change the ARP behavior from permit to deny
#
subscriber-policy 3 arp deny
#
# Change the multicast from permit to deny
#
subscriber-policy 3 multicast deny