Filter
Top Products
Installation Instructions XSM/XTM Series
9
Figure 6
Attaching Screen to Wall Mount
1. Attach wall bracket caps (H) to top and bottom of both wall
brackets. (See Figure 7)
Figure 7
2. Adjust Velcro® pull strap (if necessary) so it does not
extend beyond bottom of screen. (See Figure 8)
NOTE: NEVER place both interface brackets to one side of the
wall mount center line! (See Figure 8)
NOTE: Do NOT allow both interface brackets to be located on
same side of wall bracket. (See Figure 8)
Figure 8
XTM Model
NOTE: Proceed to Step 8 for XSM Model instructions.
3. Hang top hook of interface brackets onto the top bar of the
mount. (See Figure 9)
NOTE: The screen initially installs into the "kickstand mode" to
allow easy cable access.
4. Slide screen and bars to desired viewing position.
5. Route cables between wall and bars.
CAUTION: PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
6. Pull downward on the pullstraps and swing inward toward
wall, latching interface brackets to lower bar and locking
bottom of screen to the mount. (See Figure 9)
3d
3e
Knobs to outside
of brackets
(H) x 4
Both interface brackets must NEVER be located
to one side of the wall brackets!
Pull strap
NEVER place both interface brackets to one
side of the wall mount center line (CL)!
Center Line (CL)