Filter
Top Products
Installation Instructions MF1, MF2, PF1, PF2 Series
9
Tilting Display
The display(s) can be tilted up to 15
o
either backward or
forward from a straight upright position. In a dual stand, the
tilting is only restricted by the size of the display.
1. Turn knob counterclockwise on back of head assembly to
loosen the tilt. (See Figure 12)
Figure 12
2. Tilt display as desired, to a maximum of 15
o
either forward
or backward.
3. Turn knob clockwise to tighten display on head assembly.
(See Figure 12)
CAUTION: Tighten knob on back of head assembly to
prevent damage to the stand.
4. If leaving the display in a straight upright position, it is
recommended that a bolt (not provided) be placed through
the head assembly (see Figure 12) to lock the display into
the upright position.
Cable Management
1. Signal cables can be run down the front flap of the center
post and out the front of the post at any of the openings.
(See Figure 13)
2. The display power cord can be run through the top and
down through the post to exit out the back. (See Figure 13)
3. Any accessory power cords can be run through the front
and down through the post to exit out the back. (See
Figure 13)
4. Install the snap-on covers to any opening that is not being
used. (See Figure 13)
5. To remove the snap-on covers, grip the sides of the cover
in the middle and pull off. They can also be removed by
inserting a flat-blade screwdriver into the bottom slot and
prying them off.
Figure 13
Attaching Stand to Floor
The floor stand may be attached to the floor for a more
permanent installation.
1. Attach the floor stand to the floor using 5/16" or 3/8"
fasteners (not provided) which are appropriate for the floor’s
construction. (See Figure 14)
Figure 14
(PF1 Shown)
1
3
4
Place optional bolt
(not provided) here
to lock in an upright
position.
1
2
3
Exits for
signal cables
Snap-on
covers
Exit for
power
cables
(Front view
of center post)
(Rear
view of
center post)
Additional
fastener in
this corner
Dual Display Base
Single Display Base