Filter
Top Products
OFBU Installation Instructions
4
INSTALLATION
WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the structure to which this component is attached can
support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
1. Verify mounting brackets on wall bracket (A) can move
freely. (See Figure 1)
Figure 1
2. Locate desired installation location and slide upper
mounting plate into wall making sure bracket is seated in
channel bottom. (See Figure 2)
3. Let lower mounting plate rest against wall.
4. Using 1/2" socket, tighten tension screw until lower
mounting plate slides into channel in wall and continue
tightening until resistance is felt. (See Figure 2)
Figure 2
5. Tighten two upper and lower button head cap screws to
secure wall bracket (A) to wall. (See Figure 3)
Figure 3
IMPORTANT ! :
If the display being installed has a recessed
mounting surface, the display must be assembled to the mount
prior to mount installation. See Display Installation in the
installation instructions included with the mount being installed.
6. Install mount to OFBU following the instructions outlined in
the installation instructions provided with the mount being
installed.
x4
A
1
A
2
3
4
A
4
x4
A
5
5