Filter
Top Products
Installation Instructions MFC, PFC Series
9
Figure 11
1. Always place cart on level surface.
2. Always lock the wheels when the cart is not moving.
3. Check and tighten the hex nuts on the casters occasionally.
(See Figure 12) These should be checked especially after
use on uneven ground.
Figure 12
Removing Display from Cart
1. Remove bolt or padlock from faceplate (if used).
(See Figure 13)
NOTE: The pin may have been used as a more permanent
locking device. If so, remove nut and pin and move
from the lower holes to the upper holes.
2. Pull back on flag on upper mounting hole and press pin
down into "Open" position. (See Figure 13)
WARNING: EACH DISPLAY MAY WEIGH IN EXCESS OF
40 LBS! Always use two people and proper lifting techniques
when installing or positioning display on stand.
3. Carefully lift display from cart.
4. Lift up on pin and place flag back against faceplate to return
it to "Closed" position. (See Figure 13)
Figure 13
Push cart near
middle
Do NOT push
cart near top
x 4
2
1
Remove bolt
or padlock
if used
Pin in
"Open"
position -
Pin in
"Closed"
position -
4
move to
"Open"
position to
move to
"Closed"
position
remove
display
after display
is removed.