Filter
Top Products
KSY220 Installation Instructions
8
Figure 9
4. Close cable management bracket by sliding it back towards
the centerline of the arm (See Figure 8).
NOTE: If necessary, cable management bracket attach screws
may be tightened using hex key.
CAUTION: Ensure that adequate cable slack exists for
movement of display, and that cables will not be pinched by
installation of cover (H) or screws (G).
5. Carefully insert cables in cavity located in lower portion of
mount arm (See Figure 10).
6. Using Phillips screwdriver, install cover (H) with two
screws (G).
Figure 10
7. Repeat cable management procedures for second display.
Adjustments
Centris Head Tension Adjustment
1. If previously attached, disconnect cables from display,
remove display.
2. Using Phillips screwdriver, slightly loosen or tighten
the adjustment screw as necessary (See Figure 11).
Figure 11
3. Reinstall display. See Display Installation in this
document.
Swing Arm Tension Adjustment
1. Using 3/16" hex wrench (F), loosen or tighten adjustment
screw(s) as necessary (See Figure 12).
Figure 12
Cable Path (typical)
NOTE: Display not shown for clarity.
Cable Management
Bracket (in open position)
(G) x 2
Cable Path
(typical)
(H) X 1
Adjustment Screw
2