Filter
Top Products
CM6DH SERIES Installation Instructions
8
Figure 7
IR Sensor Placement
The placement of the IR sensor can be crucial to proper
operation of the system. A flexible IR sensor is provided to
make it easier to achieve reliable operation.
In most applications, the IR sensor may be installed on top of
the cabinet. However, tall and/or dark colored ceilings can
absorb the IR signal. If inconsistent operation is encountered
there are two alternatives.
• One, the flexible IR sensor eye can be placed so
that it gives the sensor "line of sight" to the signal
from the remote controller. Often this merely
involves placing the IR sensor so that it peeks up
over the top of the cabinet. It doesn't have to be
much, just enough to give "line of sight".
• Two, an IR sensor extension cord can be used to
position the IR sensor in the cabinet near to the
other remote controlled units. (For example, near
to the VCR or DVD player)
Install Light Dimmer Module (Optional)
With the dimmer option installed cabinet lighting can be
switched on or off or dimmed using the left buttons on the
systems remote control.
To install the optional dimmer:
1. Plug 115VAC lighting into the back of the Light Dimmer
Module.
2. Plug the other end of Dimmer Module cord into a 115VAC
grounded receptacle on motor assembly.
CAUTION: The Dimmer is for 120 volt incandescent or
Halogen lamps of at least 25 watts and should not to exceed
300 watts total.
The system also provides the option of creating and saving two
different lighting "scenes". Please refer to the Remote Control
instructions for information on how to configure "scenes".
Figure 8
System Activation
1. Insert plug from the power supply into the jack on the top of
the motor box.
Figure 9
2. Plug Powercord into 115VAC outlet.
IMPORTANT ! : A quality surge protection device is
recommended.
3. Make sure nothing is obstructing movement of doors,
4. Press and release the Activator Button on the front of the
Motor Box or the "Close Door button on the Remote Control.
(The doors should travel to the fully closed position)
7
8
From Dimmer Module
24VDC Input
Top of
Cabinet
Front of
Cabinet