Filter
Top Products
Page 7SKU 91797
For technical questions, please call 1-800-444-3353
OPERATING INSTRUCTIONS
1. Place the Fireplace Heater in the desired location for operation.
This place must be away from curtains and any other flammable material. If an
extension cord is used, it must be of the appropriate size (See page 6.). The electrical
outlet must be at least a 15 amp circuit.
2. Press the Fan Switch up to turn it on. (See Figure C below.)
3. Press the 750W Switch to enable medium heat. Press the second 750W Switch to
enable maximum heat.
4. Adjust the Temperature Thermostat Knob to the desired temperature (clockwise is
maximum).
When the unit reaches the desired temperature, the unit automatically shuts off.
When the room temperature cools down, the unit will automatically turn on.
Note: The Remote Control can be used to turn the unit on and off, and to adjust the
temperature.
5. Press the Fire Switch to turn on the fire lights inside the imitation logs.
Turn the Brightness Knob to the desired light level (clockwise is maximum).
6. When finished using the Fireplace Heater, press all switches down to the off position,
and unplug the line cord from the electrical outlet.
Figure C Control Panel
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure that all Switches of the Fireplace Heater are in the “OFF”
position and that the unit is unplugged from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
1. Before each use, inspect the general condition of the Fireplace Heater. Check for
Fan
750W
750W
Fire Lights
Temperature Thermostat Knob
Brightness Knob