Filter
Top Products
Page 2SKU 94649
Specifications
Motor
120 V, 60 Hz, 7 Amp
Pump Cord
18 Ft. - 3 Prong Plug
Discharge Size
1-1/2”
Discharge Fittings
1-1/2”, 1-1/4” and 1”
Delivery Height
26.6 Ft.
Flow Rate
3300 GPH
Horsepower
3/4 HP
Max. Particle Size
1”
Min. Water Level
4”
Operating Temp.
95° F
Min. Switch Level
3”
Dimensions
6” Dia. x 13-1/2” H
Housing Material
PP Plastic
Pump Weight
10.4 lb.
Motor Drive
Magnetic Drive
Warning: The pump should not be submerged in water deeper than the length of the
power cord, which is 18 feet long.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Avoid pump damage. Do not operate dry. Never lift or transport the pump by the
power cable or float switch cable.
2. Do not pump certain liquids. Do not pump gasoline, hydrocarbons, fuel oil,
kerosene, fats, salt or waste water, or chemical agents. Do not pump hot liquids.
3. Avoid fire or explosion. Do not pump in close proximity to flammable or explosive
materials.
4. Avoid working alone. If an accident happens, an assistant can bring help.
5. Avoid electrical shock. If the submersible pump is to be installed in a location
where a breakdown or fault could cause injury to persons, or damage to objects, the
power source must utilize a Ground Fault Circuit Interrupter (GFCI). This device will
immediately shut down power in case of a short circuit. This device must be tested
periodically. No persons should be in contact with the water being pumped.
6. Keep children away. Children must never be allowed in the work area. Do not let
them handle machines, tools, or extension cords.
7. Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
REV 07/06