Filter
Top Products
Page 4SKU 91797
For technical questions, please call 1-800-444-3353
13. When servicing an appliance, use only identical replacement parts. Follow
instructions in the “Inspection, Maintenance, And Cleaning” section of this
manual. Use of unauthorized parts or failure to follow maintenance instructions may
create a risk of electric shock or injury.
SPECIFIC SAFETY RULES FOR THIS PRODUCT
1. Maintain labels and nameplates on the Fireplace Heater. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
2. Avoid fires and explosions. Never place the Fireplace Heater near room curtains
or other flammable materials. The floor on which the Fireplace Heater sits must be
nonflammable and free of debris. Never use near flammable vapors or liquids.
3. Maintain a safe working environment. Keep the work area well lit. Make sure there
is adequate surrounding space. Always keep the work area free of obstructions,
grease, oil, trash, and other debris. Do not use this product in areas near flammable
chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
4. Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Fireplace Heater.
5. Do not force the Fireplace Heater. This product will do the work better and safer at
the capacity for which it was designed.
6. Always unplug the Fireplace Heater from its electrical outlet before performing
and inspection, maintenance, or cleaning procedures.
7. Never leave the Fireplace Heater unattended while running. Turn power off if you
have to leave the room.
8. Use proper extension cord. If an extension cord is used, use the proper type as
listed in the table on page 7. Keep extension cord off the ground and away from water.
9. Connect to a GFCI outlet. Always connect the Line Cord to a Ground Fault Circuit
Interrupter (GFCI) protected electrical outlet.
GROUNDING
Note: This product comes with a two-prong, polarized plug.
WARNING!
Improperly connecting the grounding wire can result in the risk of electric
shock. Check with a qualified electrician if you are in doubt as to whether
the outlet is properly grounded. Do not modify the power cord plug provided
with the tool or product. Never remove the grounding prong from the plug.
Do not use the tool if the power cord or plug is damaged. If damaged, have
it repaired by a service facility before use. If the plug will not fit the outlet,
have a proper outlet installed by a qualified electrician.