Filter
Top Products
6405/4410 Install
PAGE 2
5. The door trim panels have a series of snaps around the outer edges. Unsnap the door trim panel.
6. Remove the door trim panel:
Release the door handle cable by
compressing the cable lock with needle
nose pliers (as shown), rotate until ball
lines up with the slot, then lift upward.
Remove the trim panel.
7. Support the stock mirror while removing the 3 mirror mount lug nuts using a 10mm socket. Save the
stock nuts for later in the install.
8. Release the clip at the top of the mirror door bracket (as in
photo). Remove the stock mirror. Save the stock gasket and
nuts, as they will be reused.
9. Repeat this process for the passenger side.
ASSEMBLY AND MOUNTING POWER VISION MIRRORS:
1. Attach the mirror door mount bracket (“mount”) to the
mirror using 3 of the #8 screws with yellow patch provided
in the hardware bag. (Note: This is also where you can
adjust the sweep of the mirror in relation to the door later on
if necessary.)
2. Plug the cord coming through the mount into the cord under the boot.
3. Place the open end of the boot around
the lip on the mount to hold it in place.