Chemex 826 800 Humidifier User Manual


 
will automatically shut off, but will start again automatically when the reservoir is refilled.
10) When the reservoir is being filled for the first time and the wick is still dry, it will take approximately 20 minutes to drain the bottle into the
reservoir. After the reservoir has emptied, it should be refilled again to obtain maximum running time.
NOTE: We recommend using Essick Air Bacteriostat Treatment when you refill the water reservoir to eliminate bacterial growth. Add
bacteriostat according to the instructions on the bottle.
OPERATION
1) Plug cord into wall receptacle. Your humidifier is now ready for use. The humidifier should be placed at least FOUR inches away
from any walls and away from heat registers. Unrestricted airflow into the unit will
result in the best efficiency and performance.
2) The 800 Series 2-speed fan control allows you to use the low setting for the
quietest operation or a high setting for maximum output.
3) All models have an automatic humidistat. The humidistat will turn the humidifier
on when the relative humidity in your home is below the humidistat setting and
will turn the humidifier off when the relative humidity reaches the humidistat
setting. For initial operation, set the humidistat at its midpoint “two-droplet”
setting and adjust up or down from there to achieve the desired humidity level.
4) The refill light will indicate when the unit is completely out of water. The motor
will also shut off. To refill, see Step 9.
NOTE: When excessive condensation exists, a lower speed setting is recommended.
CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep grille dry at all times.
CARE AND MAINTENANCE
Cleaning your humidifier regularly helps eliminate odors and bacterial and fungal growth. Ordinary household bleach is a
good disinfectant and can be used to wipe out the humidifier base and bottle/reservoir after cleaning.
We recommend cleaning your humidifier at least once every two weeks to maintain optimum environmental conditions for your
home.
We also recommend using Essick Air Bacteriostat Treatment each time you refill your humidifier to eliminate bacterial
growth. Add bacteriostat according to the instructions on the bottle. Please call 1-800-547-3888 to order Bacteriostat Treatment
reference part#1970.
1) Turn off unit completely and unplug from outlet.
2) Lift off the chassis.
3) Roll or carry the base to cleaning basin. Lift wick from the base allowing the water to drain and remove float assembly from wick.
Rinse wick under freshwater only. Do not use soap, detergent, or any other cleaners on the wick. Leave in sink to drain.
REMOVING SCALE
4) Empty the water from the reservoir and water bottle. Fill reservoir ½ full with water and add 8 oz. (1 cup) of undiluted vinegar to
each. Let stand 20 minutes. Then empty solution.
5) Dampen a soft cloth with undiluted white vinegar and wipe out reservoir to remove scale. Rinse the water bottle and reservoir
thoroughly with fresh water to remove scale and cleaning solution before disinfecting.
DISINFECTING UNIT
6) Fill the reservoir ½ full with water and add 1 teaspoon of bleach to each. Wet all surfaces cabinet. Let solution stay for 20 minutes,
then rinse with water until bleach smell is gone. Dry with clean cloth. The outside of the unit may be wiped down with a soft cloth
dampened with fresh water.
7) Refill unit and re-assemble per ASSEMBLY instructions.
SUMMER STORAGE
1) Clean unit as outlined in Care & Maintenance section.
2) Discard used wick and any water in the reservoir or bottle and allow to dry thoroughly before storage. Do not store with water
inside reservoir.
3) Do not store unit in an attic or other high-temperature area.
4) Install new filter at beginning of season.