Filter
Top Products
4. O
PERATING INSTRUCTIONS
The LX5 can operate in Sound-Active or Auto mode, which is determined by the position of the switch
located on the rear of the unit. The mode of the unit refers to the reaction of the LEDs only as there
are no moving parts in the unit. To switch between the two modes, place the switch in either the “I” or
“O” position.
In the “I” position, the fixture operates in Sound-Active mode, the sensitivity of which can be adjusted
by the knob also located on the rear of the unit. To increase the sensitivity of the unit rotate the knob
clockwise.
In Auto Mode, the light will progress through a pre-programmed routine, whether sound is present or
not.
Switch LED
I Sound
OAuto
Troubleshooting
1) Verify that the unit is plugged into both the wall and the unit, and verify that the fuse is in
good working order.
2) If the unit fails to respond, place the unit in auto mode, listening for movement of the
motor inside the case. If no sound is heard from inside the case, replace fuse and retry.
3) If the unit is still not working, verify the integrity of the outlet with another fixture.
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location on the next page.
LX5 7
9/17/2007 12:27 PM