Filter
Top Products
DMX-1655 Manual Version 1.11 13
1313
13
Fixture life counter
1. Press the MENU button until the display reads- .
2. Press the ENTER button and the display will read the number of hours the
fixture has been in operation.
3. Press the MENU button to return to the main menu or leave for 5 seconds and
fixture will return to the normal display.
Fixture reset
Control Panel Reset
1. Press the MENU button until the display reads- .
2. Press the ENTER button to reset the fixture. All motors and mechanical parts will
return to the initial power-up positions.
Figure 3.10-1
Fixture
Channel
Level
8 255
16 240
DMX Reset
1. On your DMX controller device set the following DMX level outputs shown in “Figure
3.10-1”
2. The fixture will reset when both of the fixture channels shown in “Figure 3.10-1”
receive the specified levels.
CA-8 Easy Controller (Optional)
The easy remote controller is used only in master/slave mode. By connecting the 1/4”
microphone jack to the first unit, you will find that the remote control on the first unit will
control all the other units for Stand by, Strobe/Next/Strobe and Show 1/Slow/Show 2
functions.
Buttons Function
STAND BY Will blackout all units connected
FUNCTION or
STROBE/NEXT
In Show 1
Tap: Steps through color and gobo presets
Hold: Will strobe in white
In Slow Tap: Every 10 taps steps through each color and
the 11
th
tap changes the gobo. Repeat as necessary
to achieve desired result.
In Show 2
Tap: Steps through color and gobo presets
Hold: Will strobe in white
FAST/SLOW
LED Status Mode
Off Show 1 (210° Tilt)
On Slow Show 1 (Slow motion)
Blinking Show 2 (90° Tilt)
NOTE!
All movement and changes are sound activated except when in
SLOW Show 1 mode. In SLOW mode, color and gobo change is
user selectable using the “CA-8 Easy Controller”.