Filter
Top Products
CH-175 User Manual 7 2004-09-20/13:36
OPERATING INSTRUCTIONS
Foreword
The user buttons on this fixture will become “HOT” to the touch after a few minutes of
operation. It is important to set all manual settings within the first few minutes of
operation while the unit is cool to warm.
Operating Modes
The CH-175 can be operated in three ways.
• A stand-alone mode will listen to sound and run through 16 built in programs.
• Master/Slave mode will allow linking of up to as many units you want in a synchronized light show to
the sound.
• Can be operated remotely using the CB-FS Footswitch.
Stand Alone
CHASE SPEED
Action
1. Press the MODE button until the Chase,
blue LED turns on.
2. Adjust the Chase Speed Rotary Knob for
desired chase speed.
Notes
When you first power up the fixture the default setting
will be the Chase mode.
Chase programs will alternate automatically.
AUDIO ACTIVATED
Action
1. Press the MODE button until the Audio,
green LED turns on.
2. Adjust the Sound Sensitivity Knob for
optimum performance.
Notes
Master/Slave
The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In
this mode, the first unit in the daisy chain will automatically command all other units following.
Connecting the CH-175 for (Master/Slave) operation does not require any menu or setting selections.
Simply connect each unit in a daisy like fashion using a CH-DIN20 5 pin DIN cable. Only the first unit
in the chain can be controlled by the optional CB-FS footswitch controller.
Continued on the following page