Filter
Top Products
Hurricane™ 1100 User Manual 7 September 7, 2011
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
3. SETUP
AC Power
To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixture’s specifications chart. A fixture’s listed
current rating is its average current draw under normal conditions. All fixtures must be
powered directly off a switched circuit and cannot be run off a rheostat (variable resistor)
or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100%
switch. Before applying power to a fixture, check that the source voltage matches the
fixture’s requirement. Check the fixture or device carefully to make sure that if a voltage
selection switch exists that it is set to the correct line voltage you will use.
Fuse Replacement
Unplug the IEC power cable before replacing the fuse! Always replace with
same type of fuse.
This product has a replaceable fuse. In the event that the fuse needs to be replaced,
follow the instructions provided below.
1. Using a flat head screwdriver, remove the fuseholder from the IEC housing.
2. Remove the bad fuse from the fuseholder.
3. Insert the new fuse into the
fuseholder.
4. Install the fuseholder in the IEC
housing.