Filter
Top Products
- Pull the Tube Burner Control Knobs off of Valve Stems.
- Remove screws and washers that secure each Bezel to the Control Panel. Save removed Bezels for converting back to LP Tank Gas.
- Install new Natural Gas Bezels provided with Kit (see illustration below) in place of old Bezels onto Control Panel, and secure using previously
removed screws and washers. Assure proper alignment with control knob before fully tightening.
- Press Control Knobs back onto Valve Stems. Make adjustments needed to Bezels for free movement of Control Knobs.
Note: New bezels will change the rotation
for the control knob to properly control ignition and flames for your grill.
5
Natural Gas Bezel
Tube Burner
Control Knobs
Bezels
Valve
Stem
Lock Washers
Screws
Control Panel
Tube Burner
Incorrect
burner-to-valve
engagement
Correct
burner-to-valve
engagement
6
Reinstall Tube Burners
- Attach Electrodes to Tube Burners with previously removed screws. Reference illustration Step 3
- Insert Tube Burners into Firebox Burner holes over Valves with port holes upward, making sure Tube Burner engages Valve properly, See
Below Diagram.
- Secure Tube Burners to Burner Brackets with previously removed screws and washers. Replace Carryover tubes and secure with screws
previously removed. Reference illustration Step 2.
Reinstall Flame Tamers, Cooking Grates, and Warming Rack, reference illustration Step 1 for reinstallation.
Natural Gas Conversion Kit • 7
80004350