Chamberlain WD822KS Garage Door Opener User Manual


 
12
INSTALLATION STEP 1
Determine the Header Bracket
Location
Installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.
1. Close the door and mark the inside vertical
centerline of the garage door.
2. Extend the line onto the header wall above the
door.
You can fasten the header bracket within 4 feet
(1.22 m) of the left or right of the door center
only if a torsion spring or center bearing plate
is in the way; or you can attach it to the ceiling
(see page 13) when clearance is minimal. (It
may be mounted on the wall upside down if
necessary, to gain approximately 1/2" (1 cm).
If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13.
3. Open your door to the highest point of travel as
shown. Draw an intersecting horizontal line on the
header wall above the high point:
2" (5 cm) above the high point for sectional door
and one-piece door with track.
8" (20 cm) above the high point for one-piece
door without track.
This height will provide travel clearance for the top
edge of the door.
NOTE: If the total number of inches exceeds the
height available in your garage, use the maximum
height possible, or refer to page 13 for ceiling
installation.
To prevent possible SERIOUS INJURY or DEATH:
Header bracket MUST be RIGIDLY fastened to
structural support on header wall or ceiling, otherwise
garage door might not reverse when required. DO NOT
install header bracket over drywall.
Concrete anchors MUST be used if mounting header
bracket or 2x4 into masonry.
NEVER try to loosen, move or adjust garage door,
springs, cables, pulleys, brackets, or their hardware,
ALL of which are under EXTREME tension.
ALWAYS call a trained door systems technician if
garage door binds, sticks or is out of balance. An
unbalanced garage door might not reverse when
required.
One-piece door with horizontal track
Door
Track
Header Wall
Highest Point
of Travel
2" (5 cm) 078 0090.903 2.69402 387.07701 1464020721102 393.(0701 77014602 28 361.52.6.905302 360.45203 288.43301 361.04602 288.431 1464701 789.469403 289401 [53 2935 361.505 36185.46294020733101 1.19205602 m414.124020 7 3Tj/T15.4610966359663301 21i2 288.5316.3560248 2801781 T414.2 360.7/CS0 csQ442208.4361.83 l03 242208.4361301 301 2 m414.14.2903 Tm1 30189.192362.12201 288.65302 362.12201 288.92203 c12201 2382.84 393.c464028h5202 2]0 d 375.197lc5202 01 23 2375.1]0 4550213.82303 m360.7(all 02 3594m36093.823003 mN901 E03 360.177403612 362.1220.177403667)37(ra8.1220.61.78 03 36359.192056 289.819013 36359.167)37(ra8.12T T)37_0 2 32o5.123597/C8.1924402 3.602 35002 29c3552T230030.5 4145401 287.12T T)3902 29c33 363190901 360801 361.6267i2208.09g09 nr Wall