Filter
Top Products
2
PIR Motion Sensor Assembly &
Test
Connect the PIR
Motion Sensor box to
mounting plate with
silver screw. Tighten
screw until PIR
Motion Sensor stays
in place when
repositioned.
A Install 4 AA
Alkaline batteries
(not provided).
(Lithium batteries
recommended for
colder
environments.)
B Ensure batteries do
not touch circuit
board.
Test the PIR Motion
Sensor by waving
hand in front of
sensor. Test light
should flash after
several seconds.
Ensure Base Station (not
provided) has power.
A Ensure that Base
Station and PIR
Motion Sensor are in
close proximity to
each other. Press and
release learn button
on Base Station.
Buzzer will sound.
Mount PIR Motion
Sensor vertically on
solid surface a few feet
off the ground and
within 1000' of Base
Station. Unit should be
able to swivel as
needed.
OPTIONAL
A
B
NOTE:
Do not mount PIR Motion Sensor in direct
sunlight, near moving tree branches, or in the path of
a sprinkler system.
Secure cover with the
two large black
screws.
B Within 5 seconds, wave hand in front of PIR Motion
Sensor. Test light will illuminate and Base Station
will activate with static and feedback after several
seconds.
3' - 5'
10' - 20'
Programming PIR Motion
Sensor to Base Station
PIR Motion Sensor Installation
A
B
Vehicle Alert Installation: For cars, the best
mounting position is about 4' high, between 10-20'
back, and angled to see the back of car after passing
the sensor.
Step 1
Step 2
Step 3
Step 5
Step 6
Step 7
Step 4