Filter
Top Products
© 2006, The Chamberlain Group, Inc.
114A2590D All Rights Reserved
Resetting the 4th Push Button
Back to Security
✚
®
as Follows
Push and hold the 1st and 4th buttons while
observing the small yellow indicator light. Hold
both buttons for ten seconds until the yellow
indicator light stops blinking. The remote has
defaulted to one of six randomly preprogrammed
Security✚
®
settings.
When Several Remotes Operate One Device
To match the 974-315LM to another CGI manufactured
remote’s code (Remote Control X):
1. Begin by having both the 974-315LM and
Remote Control X available.
2. Press and hold the 1st and 4th push buttons
on the 974-315LM until the yellow indicator
light, visible on the bottom through a small
hole, begins to blink. It will blink for 30
seconds; during this time it is in the learn or
training mode, and the buttons can be
released.
3. While it is in learn mode, hold Remote
Control X, another CGI fixed or billion-code
transmitter, back to back with FCC labels
touching as illustrated.
4. Press and hold the Remote Control X
push button as you slowly slide the remotes
across each other until the 974-315LM
indicator light blinks very rapidly, indicating it
has learned the code. (If Remote Control X
is also a 974-315LM, you must press and
hold its 4th push button.)
5. The 4th button is now sending the same
identical coded signal as Remote Control X.
This code will remain inside the 974-315LM
until replaced with another new code by
repeating steps 1-4 above, or by resetting to
Security✚
®
.
Yellow
Indicator
Light
FCC Label
Remote
Control X
Yellow
Indicator
Light
Replacement Parts
3V2032 Lithium battery (2 required) . . . . . . . . . . . . . . .10A20
Visor clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137