Filter
Top Products
INSTALLATION STEP 5
Install the Single Button
Control Station
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is not connected BEFORE installing door control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing
door:
• Install door control within sight of door, out of reach of children
at a minimum height of 5 feet (1.5 m) and away from ALL
moving parts of door.
• NEVER permit children to operate or play with door control push
buttons or remote controls.
• Activate door ONLY when it can be seen clearly, is properly
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross path of closing door.
10
WHT/RED
WHT
Door Control
Connections
Single Button Control Station
Factory installed
jumper must be in
place for proper
operation. Operator
will not function
without the jumper.
132A2112-2
DO NOT EXCEED 10 DOOR OPERATIONS
PER HOUR.
FASTEN LABEL ADJACENT TO DOOR.
NE PAS FAIRE FONCTIONNER LA PORTE
PLUS DE 10 FOIS PAR HEURE.
FIXER L’ÉTIQUETTE PRÈS DE LA
PORTE.
WARNING
Keep Door in Sight at all Times When Door is Moving
Moving Door Can Cause
Serious Injury or Death
Keep Clear! Door May Move at any Time
Without Prior Warning
Do Not Let Children Operate the Door or Play
in the Door Area
Single Button Control Station
Door Control
Connections
WHT/RED
WHT
1. Remove the control station cover.
2. Fasten the control station to the wall at least 5’ (1.5 m)
above the ground. The installation surface must be
smooth and flat.
3. Select appropriate knockout and run the wires to the
operator.
4. Connect wires to the control station and replace the
control station cover.
5. Fasten the warning placards to the wall.