Filter
Top Products
26
*3-Button Remote
If provided with your door operator, the large button is
factory programmed to operate it. Additional buttons on any
Security✚
®
3-Button
remote can be
programmed to operate
other Security✚
®
door
operators.
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6-9 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
To Add or Program a Hand-held Remote Control (Not Provided)
Below are instructions for programming your operator to operate with optional Security✚
®
remote controls. A maximum of eight
Security✚
®
remote controls can be programmed to work with your operator.
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your door.
3. Release the button when the learn
indicator light blinks and shuts off
upon learning the remote control. If
the optional remote light is installed,
the light will blink.
USING THE “LEARN” BUTTON
PROGRAMMING
NOTICE: If this Security✚
®
door operator is operated with a non-rolling code transmitter, the technical measure in the receiver
of the door operator, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the
door operator does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical
measure.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• Do NOT recharge, disassemble, heat above 100°C (212°F)
or incinerate.
The lithium battery should
produce power for up to 5 years.
To replace battery, use the visor
clip or screwdriver blade to pry
open the case as shown. Insert
battery positive side up (+).
Dispose of old battery properly.
Replace the battery with only 3V2032 coin cell batteries.
THE REMOTE CONTROL BATTERY
Battery
positive
side up (+)
4. If the safety reversing sensors are not installed or
misaligned, the door will not close from a hand-held remote
control. If this occurs, the door can be closed by pressing
and holding the push button on the Single Button Control
Station until the door has closed. Releasing the push button
prior to the door closing will cause the door to reverse.