Filter
Top Products
11
INSTALLATION STEP 6
Install Remote Light
The remote light is designed to plug directly into a
standard 120V outlet.
1. Install the hinge and latch clips. Clips slide in between
the metal plate and the plastic housing on each side of
the light base (Figure 1).
2. Light should be mounted within 6' (1.8 m) of an
electrical outlet and away from any moving parts.
Select an appropriate location on the ceiling to mount
the light. Mark screw holes on the ceiling by using the
light base as a template.
3. If installing remote light on drywall and a ceiling joist
can not be located, use wall anchors provided
(Figure 2).
NOTE: No pilot hole is required for wall anchors.
4. Install the screws provided leaving 1/8" (3.1 mm)
exposed.
5. Determine the length of power cord needed to reach
the nearest outlet. Wind any excess cord around cord
retainer on the top side of the light base.
6. Install the light base by pushing onto the screws and
turning the base clockwise to lock the light in place.
7. Install two light bulbs (100W Maximum - Type A).
8. Install the light lens by hooking one end of the lens
over the hinge and pressing up on the other end to
latch into place (Figure 3).
NOTE: Light will not operate until the unit is activated.
9. Plug in the light to outlet.
To prevent possible OVERHEATING of the light socket,
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent or
compact fluorescent bulbs
WARNING
CAUTION
WARNING
WARNING
Wall Anchors
Scews
Cord
Retainer
Figure 2
Hinge Clip
Latch Clip
Metal
Plate
Plastic
Housing
Light
Base
Figure 1
Light
Lens
Figure 3
Screw #6x1" (2)
Wall Anchor (2)
Light Clip Screw
#4-20 X 7/16" (2)
HARDWARE SHOWN ACTUAL SIZE
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
WARNING
WARNING
WARNING
1. This portable luminaire has a polarized plug (one blade is
wider than the other) as a feature to reduce the risk of
electric shock.
2. This plug will fit in a polarized outlet ONLY one way.
3. If the plug does not fit fully in the outlet, reverse the plug.
4. If it still does not fit, contact a qualified electrician.
5. NEVER use with an extension cord unless plug can be
fully inserted.
6 Do not alter the plug.