Filter
Top Products
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE SMART CONTROL PANEL™
PROGRAMMING
*3-Button Remotes
If provided with your garage door opener, the large button
is factory programmed to operate
it. Additional buttons on any
Security✚
®
3-Button remote
or compact remote can be
programmed to operate other
Security✚
®
garage door
openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
* that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
✚
®
remote controls.
NOTICE: If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
LOCK
LIG
HT
KG
1
3
9
7
5
KG
1
3
9
7
5
1. Press the Prog <Learn> button on the
Smart Control Panel™.
2. Press the Prog <Learn> button again to
confirm Learn Mode.
3. Press the button on the hand-held
remote that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
LOCK
LIGHT
LOCK
LIGHT
29