Filter
Top Products
27
To Open the Door Manually
DISCONNECT TROLLEY:
The door should be fully
closed if possible. Pull
down on the emergency
release handle (so that
the trolley release arm
snaps into a vertical
position) and lift the
door manually.
The lockout feature
prevents the trolley from
reconnecting automatically,
and the door can be raised
and lowered manually as often as necessary.
TO RE-CONNECT THE TROLLEY:
Pull the emergency
release handle
toward the opener
at a 45° degree
angle so that the
trolley release arm
is horizontal. The
trolley will reconnect
on the next UP or
DOWN operation,
either manually or by using the
door control or remote.
Using the Wall-Mounted Door Control
Press the push button to open or
close the door. Press again to
reverse the door during the closing
cycle or to stop the door while it’s
opening.
THE MULTI-FUNCTION DOOR
CONTROL
Press the push bar to open or close
the door. Press again to reverse the
door during the closing cycle or to
stop the door while it’s opening.
Light feature
Press the Light button to turn the opener light on or off.
It will not control the opener lights when the door is in
motion. If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes. Press again to turn
it off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds).
A single blink indicates that the timer is reset to 1-1/2
minutes. Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes. Repeat again
for a 3-1/2 minute interval, etc., up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls. However, the door will open
and close from the Door Control, the Outside Keylock and
the Keyless Entry Accessories.
To activate, press and hold the Lock button for 2 seconds.
The push bar light will fl ash as long as the Lock feature is
on.
To turn off, press and hold the Lock button again for
2 seconds. The push bar light will stop fl ashing. The Lock
feature will also turn off whenever the “Learn” button on
the motor unit panel is activated.
Additional features when used with the 3-Button
hand-held remote
To control the opener lights:
In addition to operating the door, you
may program the remote to operate
the lights.
1. With the door closed, press and hold a small remote
button that you want to control the light.
2. Press and hold the Light button on the
Multi-Function door control.
3. While holding the Light button, press and hold the Lock
button on the door control.
4. After the opener lights fl ash, release all buttons.
To prevent possible SERIOUS INJURY or DEATH from
a falling garage door:
• If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
• NEVER use emergency release handle unless garage
doorway is clear of persons and obstructions.
• NEVER use handle to pull door open or closed. If
rope knot becomes untied, you could fall.
Lockout position
(Manual Disconnect)
Lock
Button
Light
Button
Push
Button
NOTICE
Trolley
Trolley Release
Arm (in Manual
Disconnect
Position)
NOTICE
Trolley
Release Arm
Trolley
Emergency
Release Handle
(Pull at 45° angle)
To Reconnect
Push
Button