Chamberlain 248735S 3/4 HP Garage Door Opener User Manual


 
13
INSTALLATION STEP 2
Install the Header Bracket
You can attach the header bracket either to the wall above
the garage door, or to the ceiling. Follow the instructions
which will work best for your particular requirements.
Do not install the header bracket over drywall. If
installing into masonry, use concrete anchors (not
provided).
WALL HEADER BRACKET INSTALLATION
Center the bracket on the vertical centerline with the
bottom edge of the bracket on the horizontal line as
shown (with the arrow pointing toward the ceiling).
Mark the vertical set of bracket holes. Drill 3/16" pilot
holes and fasten the bracket securely to a structural
support with the hardware provided.
HARDWARE SHOWN ACTUAL SIZE
CEILING HEADER BRACKET INSTALLATION
Extend the vertical centerline onto the ceiling as shown.
Center the bracket on the vertical mark, no more
than 6" (15 cm) from the wall. Make sure the arrow
is pointing away from the wall. The bracket can be
mounted fl ush against the ceiling when clearance
is minimal.
Mark the side holes. Drill 3/16" pilot holes and fasten
bracket securely to a structural support with the
hardware provided.
Lag Screw 5/16"-9x1-5/8"
Ceiling Mounting Holes
Door
Spring
6" (15 cm) Maximum
Garage Door
Vertical
Centerline
of Garage Door
— Header Wall —
— Header Wall —
Lag Screws
5/16"-9x1-5/8"
Vertical Centerline
of Garage Door
— Finished Ceiling —
Header
Bracket
Vertical
Centerline
of Garage Door
Vertical
Centerline
of Garage
Door
— Garage Door —
Door Spring
Lag Screws
5/16"-9x1-5/8"
Wall Mount
Optional
Mounting Holes
2x4
Structural
Support
Horizontal
Line
Highest Point of
Garage Door Travel
Header
Bracket