Filter
Top Products
35
*3-Button Remotes
If supplied with your
garage door opener, the
large button is factory
programmed to operate
it. Additional buttons on
any Security✚
®
3-button
remote or mini-remote
can be programmed to operate other Security✚
®
garage door openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All previous codes
are now erased. Reprogram each remote or keyless
entry you wish to use.
1
3
9
7
5
1
3
9
7
5
1
2
3
1
2
1. Press and release the “learn”
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
2. Within 30 seconds, press and
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs
are not installed, two clicks will be
heard.
To Add or Reprogram an Additional Hand-held Remote Control
USING THE “LEARN” BUTTON
2
1
KG
2
1
KG
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
®
remote controls.
NOTICE: If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.