Filter
Top Products
1/4 x 1-1/2"
Lag Screw
#10 - 32 x 3/8"
Screw
1/4" - 20
Lock Nut
#10 x 32
Lock Nut
Staples
1/4" - 20 x 1/2"
Carriage Bolts
Installation Step 10
Install the Safety Reversing Sensor
(Receiving and Sending Eyes)
Mounting Bracket
With Square Holes
#10-32x3/8"
Screws
"C" Wrap
#10 - 32
Lock Nuts
Mounting Bracket
with Slot
1/4" - 20
Lock Nuts
1/4 x 1-1/2"
Lag Screws
1/4-20 x 1/2" Carriage Bolts
(with square shoulder)
Inside
Garage
Wall
"C" Wrap
Mounting Bracket
with Square Holes
Inside
Garage
Wall
"C" Shaped
Wrap
Mounting Bracket
with Square Holes
1/4-20 x 1/2"
Carriage Bolts
1/4 " Lock Nuts
Drill 3/8"
Holes
Garage
Door Track
Garage DOOR Track Installation
Garage WALL or DOOR TRACK Installation
Garage WALL Installation
Figures 2, 3 and 4 show recommended assembly
of bracket(s) and "C" wrap based on the
wall
installation of the sensors on each side of the
garage door as shown on page 17, or on the
garage
door tracks
themselves.
Figures 5 and 6 are variations which may fit your
installation requirements better. Make sure the
wraps and brackets are aligned so the sensors
will face each other across the garage door.
Garage Wall or Door Track
Installation
Procedure
• Fasten the "C" wraps to the mounting brackets
having square holes, using the hardware shown in 2.
Garage Wall
Installation Procedure
• Connect each assembly to a slotted bracket, using
the hardware shown in 3. Note alignment of
brackets for left and right sides of the door.
• Finger tighten the lock nuts.
• Use bracket mounting holes as a template to locate
and drill (2) 3/16" diameter pilot holes on both sides
of the garage door, 4"-6" above the floor
but not
exceeding 6".
(See warning on page 17.)
• Attach bracket assemblies with 1/4"x1-1/2" lag
screws as shown in 3.
• Adjust right and left side bracket assemblies to the
same distance out from mounting surface. Make
sure all door hardware obstructions are cleared.
Tighten the nuts securely.
Garage Door Track
Installation Procedure
Discard slotted bracket. Drill 3/8" holes in each track
and fasten securely with hardware as shown in 4.
"C" Wrap
Inside
Garage
Wall
Mounting Bracket
with Square Holes
Garage
Floor
Mounting Bracket
with Slot
Alternate Wall Mount
Sensor
Inside
Garage
Wall
Alternate Floor Mount
Mounting Bracket
with Slot
Mounting Bracket
with Square Holes
"C" Wrap
Sensor
Garage
Floor
Indicator Light
Indicator Light
Attach with
concrete anchors
(not provided)
18
Hardware Shown Actual Size
Figure 2
Figure 5
Figure 6
Figure 4
Figure 3