Chamberlain 1146 Garage Door Opener User Manual


 
18
WIRING INSTRUCTIONS FOR
ACCESSORIES
Place entrapment warning label on the inside of
door as a reminder of safe operating procedures.
Place the manual release/safety reverse test
label in plain view on the inside of the garage
door.
T
o prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is not connected BEFORE installing door
control.
To prevent possible SERIOUS INJURY or DEATH from a
closing garage door:
• Install door control within sight of garage door, out of
reach of children at a minimum height of 1.5m, and
away from all moving parts of door.
• NEVER permit children to operate or play with door
control push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door
travel.
• ALWAYS keep garage door in sight until completely
closed. NEVER permit anyone to cross path of closing
garage door.
WARNING
CAUTION
WWARNARNINGING
WARNINGWARNING
ATTENTION
AVERTISSEMENT AVERTISSEMENTAVERTISSEMENT
AVERTISSEMENTAVERTISSEMENT
KEY SWITCH MODEL 059009
To opener terminal: white to 2; white/red to 1.
SAFETY INFRARED REVERSING SENSOR
MODEL 062153
To opener terminal screws: white to 2; Black to 3.
DOOR CONTROL PANEL 062159
To opener terminal: white to 2; white/red to 1.
INSTALLATION STEP 7
Install the Light
Press the release tabs on both sides of lens.
Gently rotate lens back and downward until the
lens hinge is in the fully open position. Do not
remove the lens. Install a 40 watt maximum (socket
size E27), light globe in the socket as shown.
• The light will turn on and remain lit for 2-1/2
minutes when power is connected. After 2-1/2
minutes it will turn off.
• Reverse the procedure to close the lens.
Replace burned out globes with rough service
light globes.
Release tabs
of lens
40W Max
Light Globe
Socket
114A2845