Vermont Casting 1655, 1656, 1657, 1658, 1659 Stove User Manual


 
4
Vermont Castings Madison
Installation
Chimneys
Your stove must be connected either to a sound
masonry chimney that meets local codes, to a relined
masonry chimney that meets local codes, or to an
approved prefabricated metal chimney. Whichever of
those types you use, the chimney and chimney con-
nector must be in good condition and kept clean.
If you use an existing masonry chimney, it must be
inspected to ensure safe condition before the stove is
installed. Your local professional chimney sweep,
building inspector, or fire department official will be
able to make the inspection or direct you to someone
who can.
The chimney should extend at least 3' (900 mm)
above the highest point where it passes through a roof,
and at least 2' (600 mm) higher than any portion of a
building within 10' (3 m).
To assure proper draft and good performance, any
chimney used with this stove should extend at least 16'
(5 m) above the flue collar of the stove.
SAFETY NOTICE: If your stove is not properly
installed, operated and maintained, a house fire
may result. For safety, follow all installation,
operation and maintenance directions. Contact
local building officials about restrictions and
installation inspection requirements in your area.
Before you begin an installation, review your plans to
be certain that:
• Your stove and chimney connector will be far enough
from combustible material to meet all clearance
requirements.
• The floor protector is large enough and is con-
structed properly to meet all requirements.
• You have all necessary permits from local authori-
ties.
Your local building official is the final authority for
approving your installation as safe and determining
that it meets local and state codes.
The metal label permanently attached to the back
of the stove indicates that the Madison has been
tested to current UL and ULC standards by CSA.
Clearance and installation information is also printed
on the label. Local authorities generally will accept the
label as evidence that, when the stove is installed
according to the information on the label and in this
manual, the installation meets codes and can be
approved. Codes, however, vary in different areas.
Before starting the installation, review your plans with
the local building authority. Your local dealer can
provide any additional information needed.
For any unresolved questions about installation,
refer to the National Fire Protection Association’s
publication
ANSI/NFPA 211–1988 Standard for Chim-
neys, Fireplaces, Vents and Solid Fuel Burning Appli-
ances
. In Canada, the equivalent publication is
CSA
CAN-B365, Installation Code for Solid Fuel Burning
Appliances and Equipment.
These standards are the
bases for many national codes. They are nationally
recognized and are accepted by most local authorities.
Your local dealer or your local building official may
have a copy of these regulations.
IMPORTANT: FAILURE TO FOLLOW THESE
INSTALLATION INSTRUCTIONS MAY RESULT IN A
DANGEROUS SITUATION, INCLUDING A CHIMNEY
OR HOUSE FIRE. FOLLOW ALL INSTRUCTIONS
EXACTLY AND DO NOT ALLOW MAKESHIFT
COMPROMISES TO ENDANGER PROPERTY AND
PERSONAL SAFETY.
Masonry Chimneys
An existing masonry chimney must be inspected to
confirm that it has a lining. Do not use an unlined
chimney. The chimney also should be examined for
cracks, loose mortar, other signs of deterioration, and
blockage. Repair any defects before the chimney is
used with your stove.
2' Min.
2' Min.
3'
Min.
0 TO 10'
3'
Min.
0 TO 10'
Fig. 2 The 2'-3'-10' Chimney Rule.
Reference Point
AC617
Fig. 3 Standard Chimney Types
A prefabricated double-
wall insulated chimney
A tile-lined
masonry
chimney
ST241