Vermont Casting VL21 Indoor Fireplace User Manual


 
720002538
WARNING: Do not allow fans to blow directly
into the fireplace. Avoid any drafts that alter
burner flame patterns.
WARNING: Do not use a blower insert, heat ex
-
changer insert or other accessory not approved
for use with this gas logset.
Do not burn solid fuels in a fireplace where an
unvented gas room heater or logset is installed.
Any outside air ducts and/or ashdumps in the
fireplace must be permanently closed at time of
appliance installation.
Preparing the Fireplace
Gas Line Preparation
Before connecting the appliance, turn off all gas appli-
ances. Close the main gas valve at the gas meter or
appliances. Close the main gas valve at the gas meter
or LP tank. Make certain there is good ventilation where
the installation will be made. Installation should comply
with all applicable building codes and ANSI Z223.1/
NFPA 54, latest edition. Use LP gas-resistant pipe com-
pound to seal threaded joints.
Installation to Existing Gas Line
There should be a manual ON/OFF valve within easy
reach of the appliance. If not, before installation of the
appliance make certain a valve is installed. There may
be a second valve on the line close to the point where
the fireplace line branches off the main gas supply line.
During installation, make certain this valve is OFF.
Manufactured Fireplace Preparation
Refer to the manufacturer’s fireplace installation manual
for the specific method of running the gas line into the
fireplace. The following method is typical of most manu-
factured fireplaces.
Insert a 1/2” gas pipe through the gas line tube provided
by the manufacturer, from outside the fireplace, as
marked by the manufacturer. An ON/OFF valve should
be placed within easy reach of the appliance. After the
gas supply is installed, reinstall the insulation removed
from the gas line tube, and pack it around the pipe, to
prevent cold air entry and to protect the gas line. (Fig.
3)
NOTE: The gas pipe should not come into contact with
any wood structure until it has reached a point at least
one (1) inch away from the fireplace side. (Fig. 3)
Masonry Fireplace Installation
Preparation
A 1/2 inch gas supply line must be supplied to the
firebox. In most cases, this will require drilling a gas line
access hole through the masonry wall. The gas supply
line should then be sealed in the access hole with mor-
tar. The gas supply line should also have a valve within
easy reach of the appliance. Use only N.P.T. black iron
gas line. (Do not use cast-iron pipe.)
Clean the fireplace and chimney (if used) of any ashes,
soot, creosote or obstructions. This will minimize any
smell from the fireplace. We recommend cleaning by a
chimney sweep.
Flue Damper Preparation
The vented fireplace damper should be fully opened
when operating the appliance as a vented log set. A
damper stop clamp with set screw is provided as a
means to prevent full closure of the fireplace damper
blade. The clamp is designed to prevent accidental
closure of the damper when in use. If the damper stop
cannot be installed, a permanent damper stop that will
keep the damper open a minimum of 1¹⁄₂” should be
installed.
Installation Instructions
1"
FP560
11/10/97
Fireplace Top View
Hole in Outer Casing
Gas Line
Tube
Ceramic
Knockout
Supply
Line
Repack
Insulation
Hole in
Outer
Casing
Ceramic
Knockout
(Both Sides)
FP560
Fig. 3 Gas line installation - factory-built fireplaces.