Vermont Casting DEF Indoor Fireplace User Manual


 
7
10005581
Vermont Castings, Majestic Products DEF/ DEFD26
1. Turn
OFF
power to the unit by unplugging the power
cord.
2. Let fireplace cool if it has been operating.
3. Remove the four (4) screws securing the bottom
louvre. Pull the louvre up and lift it out.
4. Examine the bulbs to determine which bulb needs to
be replaced.
5. While holding the socket, unscrew defective bulb(s).
6. Install the new light bulb(s) by screwing it in while
holding the socket.
7. Reinstall the bottom louvre. Follow the above
procedure in reverse order.
WARNING: Do not exceed 60 Watts per
bulb. Use of higher-rated bulbs may result
in a fire, causing property damage or
personal injury.
Maintenance of Motors
The motors used on the fan and the flame generator
assembly are prelubricated for extended bearing life
and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater unit is
recommended.
WARNING: Make sure the power is
turned
OFF
before proceeding.
Fig. 2 Trim kit installation
DEF26_3D
Trim Kit Installation
1. Peel all plastic from the Trim Kit Assembly.
2. Press the Trim Kit Assembly onto the front of the
fireplace. To facilitate the installation process, these
pieces are magnetized. Align the top of the Trim Kit
Assembly with the top of the fireplace.
Replacing the Light Bulbs
This fireplace uses two (2) clear 120 Volt, 60 Watt,
E-12 socket base light bulbs (small base, chandelier
candle type). The 60 Watt bulbs are located under the
logset/ember bed. For convenience, if one (1) of the
bulbs burns out, it will be prudent to replace both of the
light bulbs.