Filter
Top Products
10009383 29
XDV Direct Vent Gas Fireplace
Log Front Right
LG467
Figure 60
the burner tube. (Fig. 57) Adjust
the log until the pointed end on
the left is aligned with the left
edge of the bracket. Rotate the
right end of the overlay clock-
wise until it makes contact with
the back of the log front right.
(Fig. 60)
4. Place the glowing embers by
building them up lightly be-
tween the fettle and the burner
tube assembly. (Fig. 61)
Glowing Embers
LG468
Figure 61
5. Place the log front left. Set the log
by matching the square hole on the
bottom with the pins on the overlay.
The right side of this log should
come in contact with the left andiron.
Lay the log at an angle to the left
over the fettle. When this log is in
place, it must not cover the front left
opening of the overlay. (Fig. 62)
6. Place the log top center. Hold the
log with the pointed end toward
the back. Match the two holes on
the bottom of the log with the two
pins on the top of the log front
right. Set the log and lay it into
the rear log. (Fig. 62)
7. Place the log top right. Hold
the log with pointed end to the
left. Match the two holes on the
bottom of the log with the two
pins on the rear log and set the
fork on the log over the right
front log. (Fig. 62)
8. Place the lava rock on the
hearth refractory in the front as
desired. (Fig. 62)
Log Top
Center
Log Top Right
Log Rear
Log Front
Left
Glowing Embers
Log Front Right
LG469
Figure 62
Lava Rock